M2C Kyosho 16mm “ZRS” Zero Rebound System Shock Caps (4)

M2C Kyosho 16mm “ZRS” Zero Rebound System Shock Caps allow you to build an emulsion style zero rebound shock. This setup allows you to get on the gas faster after landings, and helps control roll of the car in turns by putting more pressure on the inside tire. Works with all shock pistons.

INSTRUCTIONS:

• Remove bleeder screw. fill with oil to level with top of shock. screw cap onto shock.
• Slowly push piston shaft up to top of stroke. Hold shaft up and put 2 mm screw in. (it is best to put screw in with a wrench and not a driver to avoid cross threading the screw.

NOTE:

• It is a good idea to check the shocks and rebleed if necessary to keep from building pressure due temprature changes during the day . We have also noticed that this can happen if you have a lower shock oring that is leaking.
• The video is made by Josh Hollifield for the Mugen but the build is the same for all of our ZRS shock caps. How to set up shock caps video

This product was added to our catalog on April 5, 2018